BLACK WIRED CAR ALARM + BATTERY BACKUP SIREN

BLACK WIRED CAR ALARM + BATTERY BACKUP SIREN

This multi Australian Standards approved Car Alarm & immobiliser provides two circuits of engine immobilisation operated by rolling code random encrypted remote control.
 
Entry point protection of doors, boot and bonnet with an intelligent glass break sensor. 
 
Audible warning is achieved via a 115dB Australian Standards battery back up siren, visually via the vehicle indicators and via a dash mounted high intensity red LED. 
 
The system may provide keyless entry

Proudly Australian Designed

    * Two remote controls.
    * Glass Break Sensor.
    * Locks and unlocks all doors.
    * Two Point Immobilisation.
    * Battery backup siren
    * Black Wiring.
    * Panic & Car Finder.
    * Australian Standards.

Current draw

<10mA average while armed
<250mA disarm (and for no more than 39 seconds after ignition is switched off)

Wide Operating voltage

Operating voltage +9VDC to +15VDC

Operating temperature
-20 degrees to +85 degrees for equipment designed to be installed within vehicle cabin

Polarity protection
The system circuitry is design to protect itself against accidental battery polarity reversal. This can happen when replacing the vehicle battery

Independent indicator power fuse

System uses independent fuse to power indicators, ensures short circuit in indicator circuit does not affect system operation

Short circuit protection

The power supply wire to the system is protected against an internal fault within the system
 
 
Operation:

Arming procedure while ignition is off:
The system will arm immediately if the main button of a valid remote control is momentarily pressed, the doors will lock and all security functions will become active May require additional hardware or connections.

Arming procedure while ignition is off and turbo timer is on.
The doors will lock immediately and alarm/immobiliser will arm 7 seconds after the turbo timer has finished - when the main remote button has been pressed while the turbo timer was running.
 
Disarming procedure:
The system will disarm when the main button of a valid remote control is pressed.
 
Auto Arming:
The car's engine is automatically immobilised 40 seconds after the engine has stopped. The auto-arming feature is disabled while the system is disarmed and the ignition switch is in the ON position

Immobilisation:

Dual Immobilisation Circuits.
The system features two independent 30 Amp rated, normally open immobilisation circuits, which break engine critical signals in the vehicle.
 
Starter motor, fuel pump, fuel injection, main ignition are commonly immobilised circuits.

Safety circuitry in case of power failure.
System sources alternate power from ignition if main power is lost.

Third circuit of immobilisation (optional)
Additional immobilisation circuits can be added to conform with insurance company requirements Special order required - this is not part of the standard hardware.

Protection against harsh road conditions.
All relays are fully encapsulated to provide protection against dust and moisture.


ATT: THIS AUSTRALIAN STANDARDS CAR ALARM SYSTEM MUST BE FITTED BY A PROFESSIONAL AUTO ELECTRICIAN