LED LIGHT LOAD RESISTOR - 12v - 6.8 Ohm

Our Indicator Pull Up Resistor kits are for LED light upgrades from filament lamps to LED's

This pull up resistor stops the warning light on your dash as the warning light is designed to show when a indicator light is broken.

With out the resistor your car will think that your Indicator lights were broken all of the time!

 
Description:
6.8 Ohm 25W Load Resistor.
It will fix blinker flash error, hyper or error flashing of LED Turn signal.
It works as warning canceller, decoder, capacitor
       

Detail Spec & Features:
The resistor connect across the turn signal or license plate light circuit to simulate the current load of a regular filament bulb (~2 Amp load)

To solve the problems such as hyper/error flashing, no flashing or burnt out bulb indications/error message of aftermarket installed LED lighting's.

One load resistor is required for each turn signal bulb / circuit equipped with LED lighting

 

Load Resistors Fixes:
Fix too fast flashing
Fix No flashing
Fix Dash Warning Lights coming on


Specifications:
25w
6.8ohms
12volt


Material:
Copper Heat Sink (Reduces Heat)

Dimensions:
Wire length: 12 inches Approx.
1.1" x 0.6" x 0.6"

 

ATT: The LED pull up load resistor will get very hot and work in high temperature; Do Not mount on plastic or material with low heat resistance